ULTRASONIC SOLDERING OF Cu AND Al2O3 CERAMICS BY USE OF Bi-La AND Bi-Ag-La SOLDERS

Authors

  • Roman Koleňák Slovak University of Technology in Bratislava, Faculty of Materials Science and Technology in Trnava, Institute of Production Technologies, Paulínska 16, 917 24 Trnava, Slovak Republic
  • Michal Prach Slovak University of Technology in Bratislava, Faculty of Materials Science and Technology in Trnava, Institute of Production Technologies, Paulínska 16, 917 24 Trnava, Slovak Republic
  • Igor Kostolný Slovak University of Technology in Bratislava, Faculty of Materials Science and Technology in Trnava, Institute of Production Technologies, Paulínska 16, 917 24 Trnava, Slovak Republic

DOI:

https://doi.org/10.14311/AP.2016.56.0126

Keywords:

ultrasonic soldering, Bi–based solder, lanthanum, Al2O3 ceramic

Abstract

This work deals with the effect of solder alloying with a small amount of lanthanum on joint formation with metallic and ceramic substrate. The Bi-Ag – based solder with 2 wt.% lanthanum addition and Bi solder with 2 wt.% lanthanum addition were studied. Soldering was performed by a
fluxless process on the air, by activation with a power ultrasound. It was found out that, during the process of ultrasonic soldering, lanthanum is distributed on the boundary, both with the copper and the ceramic substrate, which enhances the joint formation. The bond with Al2O3 ceramics is of an adhesive character, without the formation of a new contact interlayer.

Downloads

Download data is not yet available.

Downloads

Published

2016-04-30

How to Cite

Koleňák, R., Prach, M., & Kostolný, I. (2016). ULTRASONIC SOLDERING OF Cu AND Al2O3 CERAMICS BY USE OF Bi-La AND Bi-Ag-La SOLDERS. Acta Polytechnica, 56(2), 126–131. https://doi.org/10.14311/AP.2016.56.0126

Issue

Vol. 56 No. 2 (2016)

Section

Articles