THE INFLUENCE OF CUTTING CONDITIONS ON THE SELECTED PARAMETERS OF THE SURFACE INTEGRITY

Authors

  • Robert Čep VSB-TU Ostrava Faculty of Mechanical Engineering
  • Šárka Malotová
  • Jiří Lichovník
  • Michal Hatala
  • Stanislaw Legutko

DOI:

https://doi.org/10.14311/AP.2018.58.0334

Keywords:

residual stress, milling, machining, X-ray diffraction, surface integrity

Abstract

The article deals with an investigation of residual stress in machined surface under conditions of high-feed milling and determination of the influence of machining conditions on the size and types of stress resulting from cutting into the machined surface. As a testing material, the hardened tool steel W. Nr. 1.2343 (CSN 19552) was used. For the realization of the experimental activity, a high-feed milling head was used with exchangeable cutting inserts marked H600 WXCU 070515T. All surfaces were machined under different cutting conditions (200, 300, 350, 400 and 500mmin−1 cutting speed) in regard to the recommended parameters and machine tool options. The evaluated residual stress was measured in the depth of 8 μm under the surface with the device PROTO iXRD working on the principle of the X-Ray diffraction. Monitoring was carried out using an analysis of occurrence of tensile or compressive residual stress, and from these results, a possible dependence of the residual stress on the cutting conditions during milling process was determined.

Downloads

Download data is not yet available.

Downloads

Published

2018-12-31

How to Cite

Čep, R., Malotová, Šárka, Lichovník, J., Hatala, M., & Legutko, S. (2018). THE INFLUENCE OF CUTTING CONDITIONS ON THE SELECTED PARAMETERS OF THE SURFACE INTEGRITY. Acta Polytechnica, 58(6), 334–338. https://doi.org/10.14311/AP.2018.58.0334

Issue

Section

Articles