TY - JOUR AU - Pikna, Peter AU - Píč, Vlastimil AU - Benda, Vítězslav AU - Fejfar, Antonín PY - 2014/10/31 Y2 - 2024/03/28 TI - ANNEALING OF POLYCRYSTALLINE THIN FILM SILICON SOLAR CELLS IN WATER VAPOUR AT SUB-ATMOSPHERIC PRESSURES JF - Acta Polytechnica JA - Acta Polytech VL - 54 IS - 5 SE - Articles DO - 10.14311/AP.2014.54.0341 UR - https://ojs.cvut.cz/ojs/index.php/ap/article/view/2195 SP - 341-347 AB - Thin film polycrystalline silicon (poly-Si) solar cells were annealed in water vapour at pressures below atmospheric pressure. PN junction of the sample was contacted by measuring probes directly in the pressure chamber filled with steam during passivation. Suns-VOC method and a Lock-in detector were used to monitor an effect of water vapour to VOC of the solar cell during whole passivation process (in-situ). Tested temperature of the sample (55°C – 110°C) was constant during the procedure. Open-circuit voltage of a solar cell at these temperatures is lower than at room temperature. Nevertheless, voltage response of the solar cell to the light flash used during Suns-VOC measurements was good observable. Temperature dependences for multicrystalline wafer-based and polycrystalline thin film solar cells were measured and compared. While no significant improvement of thin film poly-Si solar cell parameters by annealing in water vapour at under-atmospheric pressures was observed up to now, in-situ observation proved required sensitivity to changing VOC at elevated temperatures during the process. ER -