Design of a Dispensing CNC Device
DOI:
https://doi.org/10.14311/TEE.2018.2.037Abstract
This article deals with the design and practical realization of a CNC device designed for the application of viscous materials, such as a thermal conducting paste. Paste is used for effective heat transfer what is essential in switched mode power supplies. However, its application on surface can be an issue. Designed CNC device serves for easier and more accurate application in production process using standard tubes.References
P. Stefanec, M. Paskala, B. Dobrucky et al., “Control System for Preheating of Molds with using PLC,” in International Conference on Industrial Technology and Management Science (ITMS 2015). Book Series: ACSR-Advances in Comptuer Science Research, vol. 34, pp. 1647-1652.
Frantisek Duchon, Peter Hubinsky, Jaroslav Hanzel et al., “Intelligent vehicles as the robotic applications,” in: 5th International Conference on Modelling of Mechanical and Mechatronics Systems (MMaMS) 2012 – MODELLING OF MECHANICAL AND MECHATRONICS SYSTEMS. Book Series: Procedia Engineering, vol. 48,pp. 105-114.
https://doi.org/10.1016/j.proeng.2012.09.492
http://www.cnc1.eu/sk/KompasH1000GSKIT.htm [cited 11. March 2017]
http://www.thomsonlinear.com/downloads/screws/Leadscrews_Ballscrews_Splines_cten.pdf [cited 14. April 2017]
Tomas Urica, Anna Simonova, Slavomir Kascak, “Control design and simulation of continuous systems,” in Electric power engineering EPE 2017 18th international scientific conference, IEEE, 2017, pp. 125-129. ISBN 978-1-5090-6405-2.
https://doi.org/10.1109/EPE.2017.7967263
http://www.linearmotiontips.com/calculate-motor-drive-torque-ball-screws/ [cited 10. may 2017]
Andrej Tereň, Pavol Špánik, Ivan Feňo, “DC/DC converters with soft (ZVS) switching,” in ELEKTRO 2001: section: electrical engineering. Žilina: University of Žilina, pp. 82-87. ISBN 80-7100-836-2.
Viliam Fedak, Frantisek Durovsky, Robert Uveges et al., “HIL Simulator of Drives of an Industrial Robot with 6 DOF,” in ELEKTRONIKA IR ELEKTROTECHNIKA, vol. 21, issue 2, pp. 14-19. Published 2015.
http://microcon.cz/ [cited 10. may 2017]
Anna Simonová, Libor Hargaš, Dušan Koniar, Zuzana Loncová, and Miroslav Hrianka, “Mathematical analysis of complete operation cycle of a system with two-position controller,” in ELEKTRO 2016 – 11th international conference IEEE 2016, pp. 213-215. ISBN 978-1-4673-8698-2 – CD-ROM.
https://doi.org/10.1109/ELEKTRO.2016.7512067
TOSHIBA, DATASHEET TB6600, www.toshiba.com
O. Hock, P. Drgona, and M. Paskala, „Simulation Model of Adjustable Arm Using Denavit-Hartenberg Parameters,“ in ELEKTRO 10th International Conference, 2014, pp. 176-179. ISBN 978-1-4799-3721-9. https://doi.org/10.1109/ELEKTRO.2014.6847896
