Remote Control and Synchronization of a Stepper Motor

Authors

  • Martin Červa Technical University of Liberec, Liberec
  • Josef Černohorský Technical University of Liberec, Liberec

Abstract

The aim of this diploma project was to create
a remote synchronization of a stepper motor. The project
covers whole development including installation,
commissioning and programming. The software
implementation is made in several tasks via PLC open. The
remote visualization is available too. The software was
created in the Automation Studio development
environment.

Author Biographies

Martin Červa, Technical University of Liberec, Liberec

Faculty of Mechatronics, Informatics and Interdisciplinary studies

Josef Černohorský, Technical University of Liberec, Liberec

Faculty of Mechatronics, Informatics and Interdisciplinary studies

References

PLCopen [online]. [vid. 14. 4. 2014]. Accessible from:

http://www.plcopen.org/pages/tc2_motion_control/

SAMEK, M., 1999. VNC – Vzdálený prístup k pocítaci. In: Root

[online]. [vid. 14. 4. 2014 ]. ISSN 1212-8309. Accessible from:

http://www.root.cz/clanky/vnc-vzdaleny-pristup-k-pocitaci/

B&R, 2013. Automation studio [software]. Version 3.0.90.28.

Eggelsberg: B&R [prístup 3.5.2014]

Downloads

Published

2020-03-30

Issue

Vol. 3 No. 4 (2014)

Section

Articles