The Gear Tooth Flank Temperature Measurements System
Abstract
This paper deals with a design of equipmentfor the temperature measurements near the gear tooth
flank. The paper describes choosing of temperature sensors
and a method of data transport from the rotating shaft. The
calibration of sensors is described too. Instructions for use
are introduced in the text. The equipment for temperature
measurements was tested on a little stand which was
specially designed. The goal of this paper is the design and
testing of equipment for temperature measurements near a
gear tooth flank.
References
V. Moravec, Z. Dejl, M. Nemcek, Z. Folta, and J. Havlík, Celní
ozubená kola v prevodovkách automobilu. VŠB-TU Ostrava, 2009.
ISBN: 978-80-7225-304-3.
A. Docekal, Design Optimization of Gearbox considering reduction
of noise emission. Ph.D. thesis, VUT Brno, 2003.
T. T. Petry-Johnson, A. Kahraman, N. E. Anderson, and D. R.
Chase, “Experimental investigation of spur gear efficiency,” in
Proceedings of the ASME 2007 International Design Engineering
Technical Conferences & Computers and Information in
Engineering, Conference IDETC/CIE 2007 September 4-7, 2007,
Las Vegas, Nevada, USA DETC2007-35045.
B.-R. Höhn, K. Michaelis, and M. Hinterstoißer, “Optimization of
gearbox efficiency”, GOMABN, 48(4), pp. 441-480, ISSN 0350-
X.
V. Moravec, Konstrukce stroju a zarízení II – celní ozubená kola.
ISBN-80-7225-051-5, 2001.
S. B. Rao and D. R. McPherson, “Gear tooth temperature
measurements,” Gear Solutions, August 2009.
M. Mazac, “Stand for Measuring Temperatures of the Main Gears
of Automobile Differential,” 54th International Conference of
Machine Design Departments, 10th-12th September 2013, Hejnice,
Czech Republic, ISBN 978-80-7372-986-8.
M. Mazac, P. Herajn, and M. Svoboda, “The Equipment for
Temperature Measurements near a Gear Tooth Flank,” 55th
International Conference of Machine Design Departments
(ICMD2014), Beroun, September 9.-12.2014, ISBN 978-80-01-
-7.
