The Construction of the Fast Resistive Bolometer for a SXR Measurement on the GIT-12 Facility

Authors

  • Jakub Cikhardt
  • Daniel Klír
  • Pavel Kubeš
  • Josef Kravárik
  • Karel Rezác
  • Ondrej Šíla
  • Alexander V. Shishlov
  • Alexey Yu. Labetsky

DOI:

https://doi.org/10.14311/1735

Keywords:

bolometers, X-rays, Z-pinches, plasma diagnostics.

Abstract

A lot of kinds of instruments are used for the SXR measurement at pulsed power facilities, but most of them are difficult to calibrate absolutely. For the determination of the energy of SXR radiated by the discharge on Z-pinches, it is possible to use the bolometer which can be calibrated analytically. The bolometer can be constructed with the sufficient sensitivity and, at the same time, with the time resolution in the order of nanoseconds. This bolometer was designed and constructed for the measurement on the 5MA facility GIT-12 at the Institute of High Current Electronics (IHCE) of the Siberian Branch Russian Academy of Sciences in Tomsk. The experiments on GIT-12 with the neon and deuterium gas-puff load were diagnosed by the copper bolometer with the time resolution of 4 ns and the sensitivity of 12 V cm2 J-1.

Downloads

Download data is not yet available.

Author Biographies

Jakub Cikhardt

Daniel Klír

Pavel Kubeš

Josef Kravárik

Karel Rezác

Ondrej Šíla

Alexander V. Shishlov

Alexey Yu. Labetsky

Downloads

Published

2013-01-02

How to Cite

Cikhardt, J., Klír, D., Kubeš, P., Kravárik, J., Rezác, K., Šíla, O., Shishlov, A. V., & Labetsky, A. Y. (2013). The Construction of the Fast Resistive Bolometer for a SXR Measurement on the GIT-12 Facility. Acta Polytechnica, 53(2). https://doi.org/10.14311/1735

Issue

Section

Articles